36V Brushless 14"(355mm) Chainsaw Tool Only (RCS36B1)

If the chain feels dry or causes tension while cutting, check the oil reservoir. Ryobi chainsaws have an automatic oiling system that requires proper lubrication. Fill the reservoir with the recommended bar and chain oil, such as Power Fit 500ml (…

Before performing any maintenance or troubleshooting, ensure the chainsaw is off, if a petrol product - ensure the engine is not running, for a battery powered saw – remove the battery, and engage the chain brake.

Excessive chainsaw vibration can result from a loose chain or cutting wood that's too thick for the unit. Ensure the chain is properly tensioned using the side knob. Check the tool’s specifications on the Ryobi product page to confirm it's…

If your chainsaw won’t start, check if the chain brake is engaged, the chain is over-tensioned, or the battery is low or overheated. Ensure the chain fits snugly but isn’t too tight, and verify the battery is fully charged and cool. Wait 15 minutes…

Watch the video in this support article to learn how to maintain your chainsaw.

If you’ve ever had an issue with oil pooling under your 18V or 36V RYOBI Chainsaw, it's usually due to a dirty chainsaw which is drawing oil out of the machine. To fix this, you need to clean it. The first thing to do when maintaining a…

Always hold the chainsaw with your right hand on the rear handle and your left hand on the front handle. Holding the chainsaw with a reversed hand configuration increases the risk of personal injury and should never be done.

To maintain your chainsaw, remove the battery, loosen chain tension, and take off the sprocket cover. Remove the old bar and chain, then install the new chain on the bar with correct orientation. Reattach the bar, loop the chain around the sprocket…

To tension your chainsaw, first remove the battery pack. Unlock the tensioner by turning the knob counterclockwise. Adjust the chain tension, aiming for a 4-5.5 mm gap between the drive teeth and the bar, tightening or loosening with the adjustment…

Inconsistent cutting may be due to a dull or incorrectly fitted chain. Sharpen or replace the chain if the teeth are worn, and ensure it's properly tensioned using the side knob. Visit the Ryobi YouTube page for sharpening tutorials.

If your chainsaw shuts down, check a few things: make sure the battery isn’t overheating, as it may go into Over Temperature Mode; avoid forcing the saw and apply light pressure instead; don’t run it at full power continuously; ensure the chain is…

Check your battery’s charge level indicator. Batteries will lose power as the charge reduces. If your battery is nearly depleted you will experience lower power than a fully charged battery. The larger the battery, the longer the chainsaw will run.…

Check your RYOBI Chainsaw battery’s charge level indicator to ensure the battery is fully charged. You should also check the battery is seated correctly in the tool, that the battery isn't too hot. Additionally, always check if the chain brake…

Check your battery’s charge level indicator. Batteries will lose power as the charge reduces. If your battery is nearly depleted, you will experience lower power than a fully charged battery.

Ensure battery is correctly inserted in charger. Make sure the battery isn’t hot. RYOBI batteries have overheat protection built into them. If the battery is too hot the charger will not start. Allow the battery to cool.

Your chainsaw is designed to cut wood only and should not be used on metal, plastic, masonry, or other non-wood materials, as doing so could create hazardous conditions and damage the tool.