How can we help?

• Drills & Drivers
• Drill Drivers
• Maintenance

How to replace the Drill Chuck

ALWAYS disconnect the tool from power before starting. You will need a PH3 Screwdriver, a 10-13mm Allen key & a Rubber Mallet. To start, locate the internal screw within the centre of the Drill chuck.

Last update: 11/09/2024, 17:52

• Grinders
• Angle Grinders
• Application

How to fit & remove Angle Grinder disc using a pin spanner

These instructions apply to RYOBI Angle Grinders with a pin spanner locking nut. The locking nut has four holes around the centre thread to position the pin spanner: You'll need a pin spanner to fit and remove the disc - don't attempt to remove the…

Last update: 13/09/2024, 12:33

• Grinders
• Angle Grinders
• Getting Started

How to fit & remove Angle Grinder disc using tool free locking nut

These instructions apply to RYOBI Angle Grinders with a tool free locking nut (FIXTEC): The locking nut will have a small tab to one side of the centre thread that can flip up, to help lever the locking nut on or off.

Last update: 13/09/2024, 12:56

• Saws
• Circular Saws
• Maintenance

How to Fit A blade onto A Ryobi Left-side Circular Saw

ALWAYS disconnect the tool from power before starting. Ensure the internal flange is placed on the spindle before fitting a circular saw blade

Last update: 12/09/2024, 13:19

• Saws
• Circular Saws
• Maintenance

How to Remove A blade from A Ryobi Left-side Circular Saw

ALWAYS disconnect the tool from power before starting. Locate the on-board hex key that will be needed to remove the blade screw

Last update: 12/09/2024, 13:22

• Nailers & Staplers
• Brad Nailers
• Troubleshooting

RYOBI Brad Nailer not firing or is misfiring

If RYOBI Brad Nailer not firing or is misfiring, disconnect the tool from the air supply before any checks and keep the tool pointed away from you. Check if there are fasteners in the magazine by dislodging the magazine latch and inspecting it…

Last update: 12/09/2024, 18:42

• Saws
• Mitre Saws
• Troubleshooting

RYOBI 210MM Compound Mitre Saw handle is jammed

If your RYOBI 1200W 210MM Compound Mitre Saw's handle is jammed, its possible the saw handle was pulled down or up with its locking pin not fully in or out and is now obstructing the movement. Check that the locking pin is correctly positioned…

Last update: 13/09/2024, 14:15