How to replace the Drill Chuck
Last update: 11/09/2024, 17:52
Applicable Models
R18PD7-0, R18DDBL-0, R18PDBL-0, R18PD3-H155S, R18CPD14, R18DD12, R18PD3-H40G, R18ID14, R18DDHE12, R18PD2422B, RDD18C, RPD18C, R18DDP2-H20G, R18DD3-0, R18CK2-H4P
- ALWAYS disconnect the tool from power before starting.
- You will need a PH3 Screwdriver, a 10-13mm Allen key & a Rubber Mallet.
- To start, locate the internal screw within the centre of the Drill chuck.
- Then insert the PH3 Screwdriver into the chuck & unscrew CLOCKWISE (Reverse thread)
- Unscrew the centre screw and remove. Do not discard.
- Insert the Allen key into the drill chuck & tighten.
- You will need to apply strong force to the Allen key ANTI-CLOCKWISE to loosen the chuck
- You may wish to use a mallet and secure the drill to apply enough force.
- Loosen by hand ANTI-CLOCKWISE and remove the chuck
Video file
Additional Support
Image
MY RYOBI
Image
PRODUCT MANUALS
Image
WARRANTY
Image
WHERE TO BUY
Image
SAFETY NOTICES
Image
