How can we help?

• Grinders
• Angle Grinders
• Troubleshooting

Why does my RYOBI Angle Grinder keep cutting out?

Angle Grinders are commonly equipped with several user safety and tool protection systems, such as overload, over-temperature, and anti- kickback. Consider the following that could be causing the issue:

Last update: 13/09/2024, 11:56

• Grinders
• Angle Grinders
• Getting Started

How to fit a guard to a RYOBI Angle Grinder

It's important the grinder is always fitted with the guard before use, and (if included in your model), the additional clip-on guard if you are cutting. You must always disconnect the power (battery or chorded) before installing or removing the…

Last update: 13/09/2024, 13:48

• Grinders
• Angle Grinders
• Application

Can I use a larger disc size with my RYOBI Angle Grinder?

Don’t use a disc larger than the maximum cutting capacity outlined below and in the product user manual, as a larger disc can cause damage to the tool, and potentially harm you or a bystander.

Last update: 13/09/2024, 11:20

• Grinders
• Angle Grinders
• Troubleshooting

RYOBI Angle Grinder disc has overtightened and jammed

Not installing the disc correctly can cause the disc to overtighten, and potentially jam the disc. To avoid this from happening, or to fix this issue and prevent this from happening again, you’ll need to remove and refit the disc:

Last update: 13/09/2024, 13:10

• Grinders
• Angle Grinders
• Application

Do I need a spanner to remove the locking nut & disc from a RYOBI Angle Grinder?

For RYOBI Angle Grinders with a tool-free locking nut, these models come fitted with a tool-free blade change nut referred to as a FixTec Locking Nut, which eliminates the need for a pin spanner. The FixTec nut also helps prevent overtightening, as…

Last update: 13/09/2024, 11:33

• Grinders
• Angle Grinders
• Troubleshooting

Can’t remove cutting disc from Angle Grinder

Typically, a cutting disc can be hard to remove because the locking nut was overtightened when fitted to the grinder. A disc will tighten under loading, so excessive tightening will cause issues with removal, that may require a pin spanner or wrench…

Last update: 13/09/2024, 13:34

• Grinders
• Angle Grinders
• Getting Started

How to fit & remove Angle Grinder disc using tool free locking nut

These instructions apply to RYOBI Angle Grinders with a tool free locking nut (FIXTEC): The locking nut will have a small tab to one side of the centre thread that can flip up, to help lever the locking nut on or off.

Last update: 13/09/2024, 12:56