SEARCH results
5 Matching results
Product Safety Recall Airwave 2-in-1 C1 Brad Nailer/Stapler RA-NBS1832-S
The product that is the subject of the recall is the RYOBI RA-NBS1832-S Airwave 2-in-1 C1 Brad Nailer/Stapler. The Product has been sold through Bunnings retailers throughout Australia from 1 October 2021 – 31 March 2024. Affected products will…
Last update: 23/05/2024, 11:43
RYOBI Brad Nailer not firing or is misfiring
If RYOBI Brad Nailer not firing or is misfiring, disconnect the tool from the air supply before any checks and keep the tool pointed away from you. Check if there are fasteners in the magazine by dislodging the magazine latch and inspecting it…
Last update: 12/09/2024, 18:42
RYOBI Brad Nailer Brads aren’t flush
The driving depth of the fastener may need to be adjusted. Test the depth on a scrap workpiece to determine the required depth for the application. To determine depth of drive, adjust the air pressure on the tool by rotating the dial on the back of…
Last update: 12/09/2024, 18:52
RYOBI Brad Nailer jamming
Disconnect the tool from the air supply before any checks and keep the tool pointed away from you. Remove fasteners from the tool. Pull up on the latch and open the Jam Release. Insert a flat blade screwdriver into the Driving Mechanism and push the…
Last update: 16/09/2024, 11:16
RYOBI Airwave/Pneumatic Brad Nailer doesn't fire deep enough
If the fastener is protruding, increase the air pressure by increments of 0.5 bar, checking the result after each new adjustment. It is preferred to adjust the depth adjustment knob to reach the preferred fastening effect. The amount of air pressure…
Last update: 16/09/2024, 11:21
Additional Support
MY RYOBI
PRODUCT MANUALS
WARRANTY
WHERE TO BUY
SAFETY NOTICES
