SEARCH
Enter keywords, product name, or question
PRODUCT SUPPORT

RYOBI Brad Nailer Brads aren’t flush

12/12/2024, 21:04

The driving depth of the fastener may need to be adjusted. Test the depth on a scrap workpiece to determine the required depth for the application.

To determine depth of drive:
  • Adjust the air pressure on the tool by rotating the dial on the back of the gun and drive a test fastener.

 

To achieve the desired depth by using the drive depth adjustment:
Step Action
1. Disconnect the tool from the air supply. 
2. Turn the depth adjustment knob left or right to change the driving depth. 
3. Reconnect the tool to the air supply. 
4. Drive a test fastener after each adjustment until the desired depth is set. 

 

Share
Applicable Models

RA-NBS1664-S, RA-NBS1832-S, RA-NB1832-S, RA-NBA1564-K, RA-NB1664-S