18 Matching results
What does a RYOBI Thicknesser do?
A Thicknesser, also known as a Planer-Thicknesser is essentially a benchtop version of a hand planer. It’s used to plane wood to a consistent thickness throughout its length. They can also be used to square off posts while at the same time removing…
Last update: 02/09/2022, 16:48
How to setup a RYOBI Thicknesser & prepare for use
Other than fitting the height adjustment handle and opening the support tables, a RYOBI Thickness Planer (also known as a Thicknesser) is fully assembled. Thicknessers are very heavy, so it’s important to mount them either securely to a bench or…
Last update: 02/09/2022, 16:49
How to clean & maintain a RYOBI Thickness Planer
RYOBI Thickness Planers (also known as a Thicknesser) produce a lot of sawdust and chips very quickly, which means they can also clog up quickly without any form of dust collection. So, it’s important to clear the machine of built-up sawdust as you…
Last update: 02/09/2022, 16:50
How to feed timber into a RYOBI Thicknesser
To feed timber into a RYOBI Thickness Planer (also known as a Thicknesser), at the front of the machine, there's a sealed power switch with emergency stop button. To turn it on, unclip and lift the cover, press the green button, and rest the cover…
Last update: 02/09/2022, 16:51
Why are there grooves in the timber when using a RYOBI Thicknesser?
If you're getting grooves in the finish surface of the timber when using a RYOBI Thickness Planer (also known as a Thicknesser), it's most likely caused by damage to one or both cutters from a foreign object in the wood like a nail. The cutter/s…
Last update: 02/09/2022, 16:52
How to setup starting height of RYOBI Thicknesser cutters
To get a starting height of your RYOBI Thickness Planer for the cutting drum, wind the handle up and slide the timber in. Next wind the handle back until the cutter just rests on the timber. Noting the position of the handle, wind it back up two…
Last update: 02/09/2022, 16:53
How much material can you take off with a RYOBI Thicknesser?
Though 3mm is the recommended maximum amount, this will depend on the hardness of the wood. The harder it is, the less per pass you should take off. Keeping to around 0.5-1mm per pass may take longer, but this process not only prevents motor…
Last update: 02/09/2022, 16:54