2000W ANGLE GRINDER KIT (230MM) (EAG2023RG)

Typically, a cutting disc can be hard to remove because the locking nut was overtightened when fitted to the grinder. A disc will tighten under loading, so excessive tightening will cause issues with removal, that may require a pin spanner or wrench…

These instructions apply to RYOBI Angle Grinders with a pin spanner locking nut. The locking nut has four holes around the centre thread to position the pin spanner: You'll need a pin spanner to fit and remove the disc - don't attempt to…

If your RYOBI Angle Grinder has a pin spanner locking nut, you'll need a pin spanner to fit and remove the disc. Don’t attempt to remove the disc without one, as it may damage the spindle.

Not installing the disc correctly can cause the disc to overtighten, and potentially jam the disc. To avoid this from happening, or to fix this issue and prevent this from happening again, you’ll need to remove and refit the disc:

The compatible disc size is dependent on your RYOBI Angle Grinder's maximum disc capacity. Don’t use a disc larger than the maximum cutting capacity outlined below, as a larger disc can cause damage to the tool, and potentially harm you or a…