How can we help?

• Application

How to setup starting height of RYOBI Thicknesser cutters

To get a starting height of your RYOBI Thickness Planer for the cutting drum, wind the handle up and slide the timber in. Next wind the handle back until the cutter just rests on the timber. Noting the position of the handle, wind it back up two…

Last update: 02/09/2022, 16:53

• Application

How much material can you take off with a RYOBI Thicknesser?

Though 3mm is the recommended maximum amount, this will depend on the hardness of the wood. The harder it is, the less per pass you should take off. Keeping to around 0.5-1mm per pass may take longer, but this process not only prevents motor…

Last update: 02/09/2022, 16:54

• Application

How do you replace the cutter blades in a RYOBI Thicknesser?

Eventually, the cutters will become dull, or they can become damaged over something like a nail in the timber passing through the RYOBI Thicknesser. In either case, the cutters need to be replaced, as original and replacement blades can't be…

Last update: 02/09/2022, 16:43

• Hedge Trimmers
• Hedge Trimmers
• Application

What's the maximum cutting capacity of my RYOBI Hedge Trimmer?

Each RYOBI Hedge Trimmers has a maximum cut capacity. Check the serial plate for your model number and refer to the following list.

Last update: 20/01/2023, 16:52

• Sanders
• Belt Sanders
• Application

How to align the belt tracking on a Ryobi Belt Sander

To align the sanding belt, reconnect the power source. Firmly hold the sander away from your body, and turn the tool on. If the belt stays running in the centre of the backing plate you won’t need to make any alignment adjustments. But if you notice…

Last update: 30/11/2022, 14:21

• Sanders
• Belt Sanders
• Application

Why does the sanding belt comes off my Ryobi Belt Sander?

The belt must be fitted in the right direction to prevent it from breaking. And it must be aligned to prevent it from coming off during use.

Last update: 15/09/2022, 14:52

• Sanders
• Belt Sanders
• Application

Why does the sanding belt rub against the body of my Ryobi Sander?

The sanding belt needs alignment. To align the sanding belt, reconnect the power source. Firmly hold the sander away from your body, and turn the tool on. If the belt stays running in the centre of the backing plate you won’t need to make any…

Last update: 15/09/2022, 14:56