36V HP™ Brushless Ground Mount Edger Tool Only (R36XEDG10)

To adjust the cutting depth, first remove the battery pack to prevent accidental starting. Locate the depth-adjusting lever near the guide wheel assembly and loosen it by pulling or rotating it to unlock. Move the wheel arm up to increase the…

To replace the blade, first remove the battery pack and wear gloves for safety. Use the included wrench to loosen the blade nut counterclockwise, then remove the old blade, clean away any debris, and install the new blade with the washers in the…

Replace the edger blade when it becomes worn or you notice a loss of performance. Always wear gloves when handling the blade, use the included wrench and holding pin for safe removal, and never attempt to sharpen the blade—always replace it with a…

If a RYOBI edger isn’t producing a clean, defined edge, check the blade condition—replace it if it’s blunt or damaged. Ensure the blade depth is set correctly, as lowering it can improve edge definition. Also, make sure the locking nut is properly…

Before operating the edger, wear proper protective gear including eye and ear protection, sturdy footwear, and long trousers. Ensure all guards are correctly installed and undamaged, keep bystanders—especially children and pets—at least 15 meters…

If your RYOBI Edger blade is wearing too quickly, it may be because you’re edging along hard surfaces – slowing down your forward movement speed will help with steadying the edger. Additionally, initial edging on long or overgrown edges or defining…