2400W Fixed Tube Blower Vacuum (RBV2400ESF)

You should avoid vacuuming leaves that are wet. Wait until they've dried out as they are much harder to suck up and will consume lots of battery runtime. Wet leaves also tend to clog up in the tube, reducing air flow and over time will degrade…

To adjust the position of the support wheels on your RYOBI 18V HP™ Garden Vacuum & Sweeper, pull up the tab at the other end to the wheels will allow you to adjust the position of the wheels to best support the bottom of the tool.

To clean the collection bag of a RYOBI 18V HP Garden Vacuum & Sweeper, with the bag turned inside-out and the plastic sleeve removed, give it a light spray with your garden hose and hang it out to fully dry before using it again.

To prevent blockages, it’s a good idea to avoid vacuuming leaves that are wet. Wait until they have dried out as they can be problematic. For starters, they are much harder to suck up, consuming lots of battery runtime. They tend to clog up in the…

It will be more time efficient if you start by blowing all the leaves in to one area before vacuuming them up. This will not only maximise battery run time, but it will also help dry any slightly damp leaves as you go. - It’s a good idea to avoid…

If your RYOBI 2400W Fixed Tube Blower has low power, it may be because you’re using too many extension leads, or the lead is too long. It is recommended to use a heavy-duty extension lead no longer than 25m.

If your RYOBI battery powered Blower Vacuum won’t start, first check if the battery is low. Check the battery has at least 1 solid bar on it’s fuel gauge. If there is a flashing single bar, it's indicating the battery is fully discharged.…

If your RYOBI battery powered Blower Vacuum won’t start, first disconnect the battery. Then, make sure the microswitch thumbscrew is tightened to ‘finger tight’ – you’ll hear an audible click to signify that the microswitch is engaged. Check for…

If your RYOBI Blower Vacuum can’t switch between modes, it may be because of a build-up of debris in the lever or deep inside the elbow.

If your RYOBI Blower Vacuum or Sweeper suddenly stops, at the top of the handle there is a red LED - if this blinks, it means the locking pin hasn’t been fully tightened. If this happens, check that the pin is finger-tight until the LED goes out.

When using a RYOBI 18V HP Garden Vacuum & Sweeper, we recommend eye and ear protection and gloves when your performing maintenance and emptying the collection bag.

This could be caused by a blockage in the tube. To check and clear this, first disconnect the battery. Then remove the main tube and check for any small sticks that might be stuck inside by looking through the tube. These are a common cause of…

If you find you can't wind the locking pin of your RYOBI 18V ONE+ Garden Vacuum & Sweeper, you need to first push the locking pin in before starting to wind it clockwise.