RYOBI Cordless Drill Driver cutting out

1. Check drill settings

• Ensure the drill is set to the correct mode (drill or drive). 
• Verify the speed setting — gear 1 provides more torque. 
• Confirm the direction selector is set to forward, not reverse. 
• Make sure the adjustable clutch is set to drill mode when drilling. 
• For more details, refer to: What are the settings for on my Ryobi drill driver?  

2. Check battery charge

• It’s normal for battery output to drop slightly as the charge decreases. 
• If the charge is too low, the tool may stop under load. 
• Recharge or replace the battery if needed. 

3. Inspect accessories

• Use the correct drill bit for the material. 
• Ensure the bit is sharp and in good condition. 
• Confirm the bit is securely tightened in the chuck. 

4. Monitor for overheating

• Overheating can occur if the tool is used beyond its rated capacity or under excessive load. 
• Refer to the product manual or Ryobi website for specific capacity ratings. 

If the tool cuts out: 

• Remove it from the workpiece. 
• Check the battery level and test the tool under no load. 
• If it operates, resume use at a slower speed or with less force. 
• If it doesn’t operate, remove the battery and allow both tool and battery to cool for 30 minutes before retrying. 

5. Clean the tool

• Check for dust build-up. 
• Clean using a dry paintbrush, blower, or rag. 
• Avoid using cleaning sprays or solvents, as moisture may damage internal components. 

6. Adjust usage technique

• Avoid applying excessive speed or force. 
• Reduce load if the tool struggles or stalls. 

Warranty support 

If the issue persists and your tool is still within the warranty period, return it to Bunnings with your receipt or proof of purchase for a warranty assessment.