Before You Begin:
• Always use 15-gauge DA Brad Nails. Using any other gauge may damage the Nailer.
To Load Nails into the Magazine:
1. Disconnect the battery from the Nailer to ensure safe handling.
2. Pull back the tension latch located on the side of the magazine until it clicks and locks into place at the rear or bottom of the magazine.
3. Insert the nails into the rear of the magazine, past the tension latch, and slide them forward as far toward the nose of the tool as possible.
4. Press the release button — the tension latch will spring forward and secure the nails in place.
o Note: If you skip this step, the nails will not be held properly in the magazine.
R18NL15-0
