36V HP™ Brushless 46cm Lawn Mower – Tool Only (R36XLMW10)

You should never wash a battery mower with a hose because water can damage the motor and electrical components; instead, remove the battery and safety key, clean the mower with a brush or cloth, use compressed air for tight spots, avoid harsh…

To prevent battery overheating, avoid mowing during the hottest part of the day, take breaks every 15–20 minutes to let the battery cool, allow it to cool for at least 30 minutes before charging, store it indoors in a cool, dry place away from…

To adjust your mower height, slide the adjusting lever forward to unlock, then lift the mower to raise the cutting height or push it down to lower it. For easier adjustment, slightly lift the handle before sliding the lever forward. Use the height…

To assemble the catcher, place the frame on a flat surface, slide it evenly into the bag with the top handle remaining outside, then pull the bag’s edges around the frame and fasten all clips so the fabric sits correctly and the handle is accessible…

To change your mower blade, begin by prioritizing safety: remove the battery and safety key, and wear protective gloves. First, disconnect the power by removing the isolator and battery. Tilt the mower onto its side with the blade vertical for safe…

To change the blade on your Ryobi lawn mower, start by ensuring safety: remove the battery and the red safety key, and wear protective gloves. Tilt the mower onto its side with the blade vertical for safe access and clean the area around the blade…

Before cleaning your RYOBI lawn mower, always remove the battery and safety isolator key, and wear protective gloves. Turn the mower on its side and clean the deck gently using a soft brush or cloth. Avoid using water or a hose to prevent damage.

To fit the mulch plug, slide the plug or catcher into the frame groove above the rear chute, where two sensors check that it’s installed correctly; if not, the mower will not start and the dashboard LED will flash orange. The design also allows the…

To start and use your Ryobi electric lawn mower, insert the isolator key, open the battery door, and click the battery into place before closing the door securely. Press and hold the start button, then pull and hold either side of the on/off trigger…

The mower’s LED interface offers three modes: ECO, SMART, and POWER. ECO locks the blade at low speed, providing the longest runtime but lower cutting performance. SMART automatically adjusts the blade speed for a balanced performance between…

The mower’s fuel gauge shows the current battery capacity. You can check it by pressing the battery button at the bottom of the user interface panel, whether the mower is on or off.

The mower’s LED interface includes three key warnings: HIGH LOAD/OVERLOAD indicates the mower is under heavy load; CATCH/MULCH shows the mulch plug or catcher is not installed; and BLADE CHECK reminds you to inspect and replace the blade if…

To vertically store your mower, first remove the battery and detach the grass catcher bag. Flip up the green latches on the sides of the handle, then push the handle down to lock it in place.

If your mower is cutting unevenly or leaving patches, the blade may be dull or damaged, as blades naturally wear down from regular use and impacts with dirt, small rocks, and sticks. A worn blade tears the grass rather than cutting it cleanly,…

Dual active battery ports allow the mower to run with either one or two batteries; using one provides standard performance, while adding a second increases power and extends runtime. For the best results, the mower should be used with two 36V HP…

If your 18V or 36V RYOBI mower cuts out while mowing, first ensure the battery is fully charged for maximum power and runtime. Always wear protective gloves and remove the battery and safety isolator key before maintenance. Check your lawn's…