18V ONE+ HP Brushless Garden Vacuum & Sweeper – Tool Only (R18XBLV20)

You should avoid vacuuming leaves that are wet. Wait until they've dried out as they are much harder to suck up and will consume lots of battery runtime. Wet leaves also tend to clog up in the tube, reducing air flow and over time will degrade…

To adjust the position of the support wheels on your RYOBI 18V HP™ Garden Vacuum & Sweeper, pull up the tab at the other end to the wheels will allow you to adjust the position of the wheels to best support the bottom of the tool.

First slide the guide wheels on to the lower blower tube. Once on, pulling up this tab allows you to adjust the position of the wheels to best support the bottom of the tool. Then attach this section to the lower vacuum tube by sliding it into…

To attach the collection bag to a RYOBI 18V HP Garden Vacuum & Sweeper, start by pulling its collar over the elbow tube. Locate the slot in the front of the collar with the tab at the front of the elbow. - Now, pull the bag handle up until it…

A RYOBI 18V HP Garden Vacuum & Sweeper motor has three speed settings controlled by pressing the up or down buttons. Pressing and holding the power button again for 2 seconds will turn off the motor.

To clean the collection bag of a RYOBI 18V HP Garden Vacuum & Sweeper, with the bag turned inside-out and the plastic sleeve removed, give it a light spray with your garden hose and hang it out to fully dry before using it again.

To access the fan blade, you need to remove the motor from the main handle. To do this, first loosen the safety pin about three quarters of the way. Then slide and hold the button to the unlock position as you twist the motor apart from the front…

To prevent blockages, it’s a good idea to avoid vacuuming leaves that are wet. Wait until they have dried out as they can be problematic. For starters, they are much harder to suck up, consuming lots of battery runtime. They tend to clog up in the…

Holding the power head angled slightly down at the back, align the square openings of the lower blower tubes and push them partially together. Now, line up the opening of the power head with the vacuum tube. Then, as you push them together, make…

To detach the motor from the handle, first loosen the safety pin about three quarters of the way. Then slide and hold this button to the unlock position as you twist the motor apart from the front handle. To refit the motor, line up the locating…

Our zipless bag design makes this job easy. Simply unhook the bag and then slide off the plastic sleeve and empty the contents. You should empty your collection bag when it's full and after every use.

To clean the collection bag of a RYOBI 18V HP Garden Vacuum & Sweeper, with the bag turned inside-out and the plastic sleeve removed, give it a light spray with your garden hose and hang it out to fully dry before using it again.

To turn a RYOBI 18V HP Garden Vacuum & Sweeper on, press and hold the power button located on the top of the handle for two seconds. To turn off, press and hold the same power button for two seconds.

It will be more time efficient if you start by blowing all the leaves in to one area before vacuuming them up. This will not only maximise battery run time, but it will also help dry any slightly damp leaves as you go. - It’s a good idea to avoid…

If your RYOBI battery powered Blower Vacuum won’t start, first check if the battery is low. Check the battery has at least 1 solid bar on it’s fuel gauge. If there is a flashing single bar, it's indicating the battery is fully discharged.…

If your RYOBI Battery powered Blower Vacuum has lost suction and isn’t vacuuming well, make sure the bag is empty and clean, as this can impact the performance of the unit. Also check for debris in the tubes, around the propeller or in the elbow as…