Troubleshooting – RYOBI 18V ONE+ HP Brushless 30–34° Framing Nailer
If your nailer isn’t firing correctly, check the following:
• Battery low or insufficient capacity
Ensure the battery is fully charged.
A fully charged 4.0Ah battery can fire approximately 750 nails.
• Tool not activated
Confirm the nailer is activated — the LED will glow green when the grip switch is squeezed (without the nosepiece depressed).
• Incompatible nails
Make sure you're using nails that meet the tool’s specifications.
See: What type & size nails are suitable for the 18V ONE+ HP Brushless 30–34° Framing Nailer?
• Damaged or rusty nails
Inspect nails for damage or corrosion. Replace if necessary.
• Magazine tensioner not positioned correctly
Check that the nail tensioner is properly engaged.
See: How to fire nails with a RYOBI 18V ONE+ HP Brushless 30–34° Framing Nailer
• Insufficient pressure on the workpiece
Apply firm pressure with the nosepiece fully depressed before pulling the trigger.
• Grip switch not depressed
Ensure the grip switch is squeezed while the nosepiece is pressed against the workpiece.
• Incorrect air tank pressure
Check that the internal air tank is pressurised to 125 PSI / 8.2 bar.
If needed, see: How to top up a RYOBI 18V ONE+ HP Brushless 30–34° Framing Nailer with air
RFN1830X
