Why does my RYOBI Thicknesser stop during use?
Last update: 02/09/2022, 16:55
Applicable Models
RAP1500G
- If during use your RYOBI Thicknesser just stops, it’s probably because you’re attempting to remove too much material in a single pass, which can overload the motor.
- Simply hit the stop button, wind up the handle and then press the overload button to reset it.
- Remember to then avoid taking too much material off in a single pass.
Additional Support
Image
MY RYOBI
Image
PRODUCT MANUALS
Image
WARRANTY
Image
WHERE TO BUY
Image
SAFETY NOTICES
Image
