If your RYOBI Petrol Blower is running poorly, try the following troubleshooting steps:
Follow the correct starting process:
- Press the primer bulb 10 times.
- Pull the choke out to full.
- Pull the starter cord until the engine sounds like it is about to start but no more than 5 times.
- Push the choke in to half.
- Pull the starter cord until the unit starts.
- Squeeze and release the trigger a few times.
- Let the unit sit on idle for 15-30 seconds before use.
Check for flooded engine
A flooded engine will cause a Blower to not start. A flooded engine means there is excessive fuel pumped into the engine, which has displaced the oxygen needed to start the Blower. If you have attempted to start the engine unsuccessfully there is a chance your engine is flooded. Let your Blower sit for 15-20 minutes before starting it again following the correct starting procedure.
Stale fuel
A common cause is stale fuel. Fuel starts to lose its volatility after 30 days. This will affect the ignition of an engine. Replace your fuel with some fresh fuel and see if this helps. You can also buy fuel stabiliser that will keep fuel fresh for 12 months. You can purchase this from your local Bunnings store.
Dirty air filter or spark plug
Another common cause of a hard-to-start motor or a roughly running motor is a dirty air filter or spark plug. These parts should be inspected regularly and do require replacement throughout the life of a Blower. To find and order the correct replacement filters and spark plugs for your unit. contact your local Bunnings Special Orders desk and quote your blower model number to the staff.
Incorrect fuel mixture
Incorrect fuel mixture can cause the Blower to not start or run roughly, make sure you are using the correct fuel mixture with your blower. Ryobi Blowers run off a 50:1 ratio, this means 50 parts unleaded fuel to 1 part 2-stroke oil.
Choke left on
The choke being left on will cause your Blower to not run correctly and shut off. Once your Blower has started, make sure it is in the ‘run’ position. Make sure to follow the correct Blower starting procedure.
Disconnected spark plug
The spark plug lead can sometimes be disconnected. Make sure the spark plug lead is connected properly.
RBL26G, RBV254O
