- Carefully remove the product and any accessories from the box. Inspect the product carefully to make sure no breakage or damage occurred during shipping. Do not discard the packing material until you have carefully inspected and satisfactorily operated the product.
- Top half Assembly - align holes of the top panel and upper back panel. Insert M5 bolts through the two centre back holes of the panels. Secure with them with M5 nuts.
- Side panel Assembly - Align holes in the top panel and right-side panel. Insert M5 bolts through side hole and back holes of the panels. Secure with M5 nuts. Repeat steps to attach the left side panel.
- Bottom half Assembly - Slide lower back panel up between side panels until top edge moves behind the lip of upper back panel. Insert M5 bolts through the back holes of the panels. Secure with M5 nuts. Align holes in the bottom panel with holes on the lower back and side panels. Insert M5 bolts through the side holes and back holes of the bottom panel. Secure with M5 nuts. Insert M4 bolts through the front facing corner holes of the cabinet. Secure with M4 nuts.
- Shelf installation - Insert shelf clips into the slots in the interior of the cabinet. Make sure shelf clips are all on the same level. Insert interior shelf into cabinet by tilting shelf diagonally and placing onto shelf clips.
- Door installation - Install cabinet doors by inserting into the hinge. Run it through the hinge hole.
- Mounting Installation - for ease of installation, remove shelf and doors from cabinet before mounting onto a length of LINK wall rail or to wall studs. Insert bumpers into the round holes on the bottom back panel of the cabinet. With the help of at least one other person, carefully lift the cabinet and position the cabinet onto five of the raised octagonal patterns on the LINK wall rail to ensure the cabinet is seated properly. Check that the holes through the back wall of the cabinet are lined up with the corresponding holes on the LINK rail. Insert number eight screws into the holes for extra support. Install cabinet doors by inserting hand drop through the hinge hole.
00:13:37:05 - 00:14:03:23
Unknown
If mounting directly to a wall. Locate the studs behind your wall using a pencil and a level mark four screw holes. The top two screw holes should be 16in apart on studs. The bottom screw holes should be 18 and one eight inches below the top screws. Using a drill make for pilot holes slightly smaller than the screws. Using a Phillips bit, install the screws through each of the pilot holes.
00:14:04:00 - 00:14:28:06
Unknown
Leave the head of the screw approximately a quarter inch off the wall with the help of at least one other person. Carefully lift the cabinet and align the key holes on the back with the screws in the wall. Place the wide portion of each keyhole over the head of each screw to lock the cabinet in place. Slide the cabinet down until the screws are inside the narrow portions of each keyhole.
00:14:28:08 - 00:14:33:01
Unknown
Tighten screws until snug.
00:14:33:03 - 00:14:48:21
Unknown
Install cabinet doors by inserting handrail through the hinge hole
RLWMC
