How to set a RYOBI Pressure Washer to dispense soap

Last update: 22/01/2023, 18:50

Applicable Models

RACPWS2, RACPW140

  • Depending on the Pressure Washer you own, the soap dispenser will be located in the front or back. 
  • If your Pressure Washer has a feed tube, it's important that when you put the cap back on, that the tube is pushed all the way to the bottom of the container - otherwise it won't draw all of the soap up
  • Regardless of the model, soap will only dispense in low pressure mode.
  • Ensure you have the lance set to low pressure.
  • Ensure you’re using the low-pressure tip.
  • Allow up to 45 seconds for the soap to dispense.
  • Ensure the soap feed tube is pushed all the way down into the container.
  • Check the level of soap in the container.

 

Additional Support