How to load staples into a RYOBI 18V ONE+ Stapler

Before you begin:

Make sure you’re using T50 staples with a crown or width of approximately 10mm or 3/8 inches, as any other gauge or type will damage the stapler.
We recommend 10mm T50 Staples.

Step	Action
1.	Remove the battery from the Stapler before loading Staples into the magazine.
2.	At the bottom of the magazine, depress the toggle switch to release the magazine.
3.	The magazine can now be pulled back exposing the track to lay the staples. Image
4.	Load the staples into the magazine track cavity. Image
5.	Return the magazine cartridge by pushing back until you hear it click into place.

Applicable Models

R18ST50-0