How to assemble & adjust the seat on a RYOBI 80V 30" Lithium Zero Turn Ride-On Mower

Last update: 17/03/2023, 12:37

Applicable Models

R80XZTR30

To assemble the seat: 
Step Action
Note All tools are included with exception of a socket wrench with a 13mm, a pair of sharp scissors as well as a tyre pressure gauge. 
1. Position the seat over the mounting brackets then, align the seat clip as you lower it down, so it's secured onto the mounting bracket.
2. Then, attach the two seat retainer cables by their carabiner clips.
3.

Connect the seat safety interlock cable connector to the plug on the mower until it clips into place, then you can lower the seat. 

It’s important that the connectors click in to place, or the mower may not run. 

To adjust the seat: 
Step Action
1.  To move the seat forward or backward, lift and hold the seat adjustment lever.
2. Then slide the seat to the desired position. Release the lever and make sure the seat is locked in position before operating the mower. 

Additional Support