SEARCH
Enter keywords, product name, or question
To connect an air hose or air tool from your Compressor:
| Step | Action |
|---|---|
| 1 | Make sure the air compressor is turned off and unplugged from the power source. |
| 2 | Rotate the pressure regulator knob fully counter-clockwise. |
| 3 | Confirm that the outlet pressure is at zero (0) bar. |
| 4 |
Attach the male hose connection to the 6.35mm (1/4 in.) coupler on the air compressor. Make sure to push the male hose connector firmly into the female coupler. The connector sleeve will then spring forward and lock the male connector in to place.
|
| 5 | The air pressure can then be set on the pressure regulation to meet the tools requirement. |
To disconnect an air hose or air tool from your Compressor:
| Step | Action |
|---|---|
| 1 | Rotate the pressure regulator knob fully counter-clockwise. |
| 2 | Confirm that the outlet pressure is at zero (0) bar. |
| 3 | When disconnecting a hose from a 6.35 mm (1/4 in.) quick coupler, always firmly hold the release end of the hose. |
| 4 | Pull back the release sleeve on the 6.35 mm (1/4 in.) quick coupler. |
| 5 | With a firm grip, pull out the quick connect air fitting that is attached to the quick coupler. |
RA-C2550-G, RC40A-G, R18AC-0
